One of the nicer things about working with ABS is that the cement is very thick and you can use it as a gap filler to seal off cracks and imperfections and then sand it down after it all dries. Do not use any other type of cement with ABS plastic. When you glue it together be sure to use plenty of ABS cement. At this point you can reheat the plastic and adjust things somewhat, once you glue everything together it’s not so easy Hey it works for me.īefore moving on to the next step you will need to test the fit and make sure that your battery fits properly. In the interest of time and since this motorcycle is going to be another deliberate neo-rat, I simply heated the plastic along the bend lines until it was bendable and then used two blocks of wood to form it to shape. If you have enough equipment and desire absolute perfection you should carefully clamp each corner to be folded and follow the procedures shown above. These tabs my not really be necessary but I like the security of having large bonding surfaces to hold parts like this together, especially in a high vibration environment like a motorcycle.īending the sides up to form the box takes a little more thought. To get a really good square corner take a slab of wood or another piece of metal and press down on the corner and hold it for a minute as it cools.Īfter this I bent the tabs in for the sides. When it gets warm it will bend very easily. First you clamp it into a vise sandwiched between a couple of metal angles and start heating it. It will get reshaped even more later but for now let’s just bend it to a nice 90 degree angle. The first piece to get bent is the lower brace. It is your responsibility to take all reasonable precautions to see that you don’t get hurt. This next step involves extremely high heat, possible hot metal & molten plastic.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |